HOTDOG 20 WP

Explanation
PREPARATION OF PLANT PROTECTION PRODUCT FOR APPLICATION:

The plant protection product calculated over the recommended dosage is first mixed with some water in a separate container. The tank of the application machine is half filled with water. While the mixer of the machine is running, the mixture is added to the tank. The mixing is continued and the tank is completed with water. Mixing process continues until the application is completed. Use the prepared plant protection product on the same day.

Calibration:

Before the application, the calibration of the application machine should be done. The amount of mixture to be given to the specific area should be well adjusted in order to provide a good coating in the application. Applications should be done during the cool hours of the day in windless or less windy weather conditions.

CLEANING OF THE SPRAYING MACHINE:

Empty the sprayer tank safely immediately after the application is completed. After filling the tank with clean water, run the mixer and spray system to ensure that all parts are washed. Do not perform washing operations beside water sources. Do not pour wash water and waste into water sources

HOW TO USE THE PLANT PROTECTION PRODUCT:

Apple - Two-point red spider and European red spider: Application should be made when an average of 8-10 live individuals per leaf is seen in periodic counts to be made from 100 leaves.

Tomato (greenhouse) - Tobacco whitefly: It is entered in terms of diagonal in the area determined to be contaminated with whitefly. Each head step is collected by making 50 from the lower, middle and upper leaves. Chemical combat is applied when there are 5 larvae + pupae per leaf.

Tomato (greenhouse) - Tomato pasaar: Leaf samples are taken in plants that take the color of rust by examining especially the parts of the plants close to the soil. The leaves are examined under a stereo binocular microscope and pests are sought. Local application is done in the plants where the pest is seen and its surroundings. The plants are examined at intervals of two or three days and if spread, the whole area is applied.

INFORMATION ABOUT RESISTANCE:

The plant protection product named HOTDOG 20 WP is an Acaricide classified as Group 21A according to its mechanism of action. Repetitive applications of plant protection products with the same mechanism of action promote resistance development. For this reason, to delay developing resistance, do not exceed total application number of HOTDOG 20 WP in the same season. In cases where the application should be repeated, pay attention to the use of plant protection products with a different mechanism of action (other than Group 21A).

MIXTURE STATUS:

It can be mixed with other insecticides and fungicides except bordo slurry. It is recommended to make preliminary mixture tests before making a large amount of mixture for application.

• Read the label first.
• Do not use at home
• Keep away from children, food and animal feeds.
• Use a mask, protective suit, gloves and goggles.
• Do not eat, drink or smoke during the application of the plant protection product.
• Do not let people and animals enter the field for 1 day.
• To prevent risks to human and environmental health, use as recommended and at the recommended dosage.
• It is strictly forbidden to use other than the recommended products.

POISONING SYMPTOMS:

Vomiting, diarrhea, headache, low blood pressure, dysfunction of breathing and heartbeat.

FIRST AID MEASURES:

After inhalation: Remove patient to fresh air. If breathing is irregular or stopped, administer artificial respiration. Keep the patient in a warm and comfortable place. Call a doctor or poison information center immediately.

After Skin Contact: Immediately take off any contaminated clothing. Wash the body parts of the medicine with plenty of water and soap for 15-20 minutes. If skin irritation persists, call a doctor. Wash contaminated clothing before using it.

After Eye Contact: Immediately wash the eyes and under the eyelids with plenty of water for 15 minutes. Remove contact lenses, if present. Get medical attention immediately.

After Swallowing Contact: If swallowed, seek medical advice with the product label or this information sheet. Never give anything by mouth to the unconscious patient and do not force them to vomit.

ANTIDOTE and TREATMENT:

It has no special antidote. It has no special antidote. Treatment is applied according to the symptoms.

NATIONAL POISON CENTER (UZEM) TEL: 114

CONTENTS:

pyridaben

HAZARDOUS EXPRESSIONS (H)

H301: Toxic if swallowed.

H315: Causes skin irritation.

H318: Causes serious eye damage.

H319: Causes serious eye irritation.

H331: Toxic if inhaled.

H335: May cause respiratory irritation.

H400: Very toxic in the aquatic environment.

H410: Long-lasting, very toxic effect in the aquatic environment.

Precautionary Statements (P)

P261: Avoid breathing spray.

P273: Avoid release to the environment.

P280: Wear protective gloves / protective clothing / eye protection / face protection.

P405: Store locked up.

P501: Dispose of contents / container to National Environmental Legislation.

EUH401: Follow the instructions for use to avoid risks to human health and the environment.

MATTERS TO BE CONSIDERED WHEN USING AND STORING:

• It is poisonous to the bees, do not use the time of flowering.
• It is poisonous to fish, do not contaminate underground and surface waters.
• It is poisonous to the fish. Avoid getting the medicine and its residues into fountain troughs, wells, lakes, ponds and streams.
• It is not phytotoxic when used according to the advice.
• Wash the spraying equipment thoroughly after spraying.
• Keep the medicine in a cool dry, well-ventilated place, in its own packaging, with its mouth closed.
• Follow the safety precautions and recommendations exactly, do not use empty medicine packages for any other purpose.

STORAGE STATUS:

When stored unopened in its original packaging under normal (cool and dry) conditions, there is no change in the physical, chemical and biological properties of the product outside the tolerance limits for 2 years.

COMPANY STATEMENT:

The manufacturers guarantee the quality of plant protection products provided that they are sold in their original packaging. Manufacturers do not accept responsibility for any damage caused by improper storage of plant protection products or deficiencies in following recommendations.

LICENSE OWNER AND MANUFACTURER COMPANY:

ERTAR KİMYA Agricultural Products Tools Manufacturing Market. Singing. ve Tic. Ltd. Sti.

Acıdere OSB Mahallesi Zafer Cad. No: 8 Saricam / ADANA

Tel: 0 (322) 456 19 45 Fax: 0 (322) 456 19 47

info@ertarkimya.com.tr www.ertarkimya.com.tr

PLANTS AND PESTS THAT IT IS USED FOR: