BENDIS

Explanation
PREPARATION OF PLANT PROTECTION PRODUCT FOR APPLICATION:

The plant protection product calculated over the recommended dosage is first mixed with some water in a separate container. The tank of the application machine is half filled with water. Medicated water is added to the tank while the mixer of the machine is running. The mixing is continued and the tank is completed with water. Mixing process continues until the application is completed. Use the prepared plant protection product on the same day.

CALIBRATION: Calibration of the application machine should be done before the application. The amount of mixture to be given to a certain area should be well adjusted in order to provide a good coating. Applications should be done in cool hours of the day in windless or less windy weather conditions.

CLEANING OF APPLICATION TOOLS:

Empty the application machine's tank safely immediately after the application is completed. After filling the tank with clean water, run the mixer and spray system to ensure all parts are washed. Do not wash near water sources. Do not discharge washing water and wastes into water sources.

USAGE OF PLANT PROTECTION PRODUCT:

BAĞ MİLDİYÖ: The first application should be started when the shoots reach 25-30 cm. The second and subsequent sprayings are applied with an interval of 10-15 days, taking into account the duration of the first drug and the development state of the disease and meteorological factors.

VINTAGE ASHTRAY Erysiphe necator

1st spraying: When the shoots are 25-30 cm before the flower,

2nd spraying: Before the flower buds are separated before flowering,

3.Dispositions: During the period when the flower petals are falling and the small pellets of the groves are large,

4 and other sprayings: After the third spraying, depending on the duration of the drug used, the grains are made until I fall.

BAĞ ÖLÜKOL: * Summer Spraying:

1.When spraying shoots are 2-3 cm,

2.When spraying shoots are 8-10 cm,

3.The spraying shoots should be done in the circuit where it reaches 25-30 cm.

CIGARETTE CABACILES MILLIUS: Spraying is started when the plants start to throw arms or with the first symptoms of the disease, and according to the severity of the disease, sprayings should be done to cover all parts of the plant, especially under the leaves.

Cucumber and Pumpkin Ashing: Spraying is started when the first signs of disease are seen. Depending on the severity of the disease, climatic conditions and duration of the drug, disinfection should be continued. Spraying should be interrupted when the daily average temperature is above 27oC and the relative humidity is below 50%.

TOMATO MİLDİYÖ: It is started to be applied to the fight against medication with the appearance of white ash under the 3-5 mm diameter brown spots on the tomato leaves in the surrounding areas or when the disease is seen every year, when the conditions are suitable for the disease. Depending on the course of the disease and climatic conditions, disinfection is continued at 10-12 day intervals.

TOMATO EARLY LEAVE BURN: Spraying should be started as soon as the first spots appear on both seedlings and field. When the climatic conditions are suitable for disease development, spraying should be repeated depending on the duration of the drug.

PEPPER (GREENHOUSE) CASTING: Spraying should be started when the first signs of disease are seen on the plants and, if necessary, continue spraying every 10-12 days.

KARPUZ ALTERNARIA LEAF BURN: Chemical spraying is applied in the form of green parts spraying. Application should be started with the first symptoms in the environment. Disinfection is continued at 10-12 day intervals, taking into account the severity of the disease, climatic conditions and duration of drug administration.

PADDY BURN DISEASE: For green part spraying, spraying should be done when the disease is first seen. When necessary, second and third sprayings should be made, taking into account the duration of the drug used.

INFORMATION ABOUT RESISTANCE:

The plant protection product named BENDIS is a fungicide classified as Group C3: 11 according to its mechanism of action. Repetitive applications of plant protection products with the same mechanism of action promote resistance development. For this reason, in order to delay the development of resistance, do not exceed the total number of applications of BENDIS recommended during the same production season. In cases where the application should be repeated, pay attention to the use of plant protection products with a different mechanism of action (except for Group C3: 11).

MIXTURE STATUS:

It is not recommended to use BENDIS in tomato applications by mixing with spreading adhesives.

  • read the label first.
  • do not use at home.
  • keep away from children, food and animal feed.
  • Use a mask, protective suit, gloves and goggles.
  • Do not eat, drink or smoke during the application of the plant protection product.
  • Do not let people and animals enter the field for 1 day.

POISONING SYMPTOMS:

Diarrhea with nausea, vomiting, and abdominal pain may occur following significant uptake.

AFTER INHALATION: Move to fresh air. If breathing is irregular or stopped, administer artificial respiration. Keep the patient warm, rest. Call a doctor or call the Poison Information Center immediately.

AFTER SKIN CONTACT: Immediately take off clothing with medication. Wash the contaminated areas with plenty of water immediately. If skin irritation is permanent, consult a doctor. Wash the clothes washed with the medicine without using it again.

AFTER EYE CONTACT: Immediately rinse eyes with plenty of water, including eyelid, for at least 15 minutes. If contact lenses are used, remove them. Seek medical attention immediately.

AFTER SWALLOWING: If swallowed, seek medical advice with the product label or this information sheet. Never give anything by mouth to an unconscious patient and do not force them to induce vomiting.

ANTIDOTE AND TREATMENT:

It has no special antidote. Treatment is applied according to the symptoms. Wash the stomach, making sure that the stomach contents do not get into the respiratory tract.

CONTENTS:

the 1.Azoxystrob

HAZARDOUS EXPRESSIONS (H):

H331: Toxic if inhaled.

H400: Very toxic in the aquatic environment.

H410: Long-lasting, very toxic effect in the aquatic environment.

of the product used. pour the rinse water into the spraying tank. repeat this process 3 times.

Precautionary Statements (P):

P261: Avoid breathing spray.

P271: Use only outdoors or in a well-ventilated area.

P273: Avoid release to the environment.

P280: Wear protective gloves / protective clothing / eye protection / face protection.

P311: Call the POISON CENTER or doctor / physician.

P391: Collect spillages.

P304 + P340: IF INHALED: If breathing is difficult, take victim to fresh air and keep it in a comfortable position for easy breathing.

P501: Dispose of contents / container in accordance with local regulations.

EUH401: Follow the instructions for use to avoid risks to human health and the environment.

MATTERS TO BE CONSIDERED WHEN USING AND STORING:

  • It is poisonous to the fish.
  • Do not contaminate stagnant or stream sources used with medication during the disposal of drug residues.
  • Keep pets away from the disinfected area.
  • Do not contaminate feed and foodstuffs with medication.
  • Dispose of the increased medicine by embedding it away from water sources at the accepted place for pesticides.
  • Pour the unused medicine mixture into the unused soil and dispose of it.
  • Empty the packaging thoroughly.

STORAGE STATUS:

When stored unopened in its original packaging under normal (cool and dry) conditions, there is no change in the physical, chemical and biological properties of the drug for 2 years outside the tolerance limits.

COMPANY STATEMENT:

The manufacturers guarantee the quality of their medicines provided that they are sold in their original packaging. Manufacturers do not accept responsibility for any damage caused by improper storage of medicines or deficiencies in following recommendations.

LICENSE OWNER AND MANUFACTURER COMPANY

ERTAR KİMYA Agricultural Products Tools Manufacturing Market. Singing. ve Tic. Ltd. Sti.

Haci Sabanci Organize Sanayi Zafer Cad. No: 8 Saricam / ADANA

Tel: 0 (322) 456 19 45 Fax: 0 (322) 456 19 47

info@ertarkimya.com.tr www.ertarkimya.com.tr

PLANT AND HAZARDOUS ORGANISMS TO BE USED:

Plant Name

Harmful Organism Name

Administration dose

Time Between Last Application and Harvest

vineyard*

Vineyard midi (Plasmopara viticola)


Ashing (Erysiphe necator)

Dead arm(Phomopsis viticola)

(Summer spraying)

75 ml/100 L water

21 day

Cucumber

Cucurbit Mildio (Pseudoperonospora cubensis) 60 ml/100 L water

3 day

Cucurbit Ash (Erysiphe cichoracearum, Sphaerotheca fuliginea)

75 ml / 100 L water

3 day

Pumpkin

Cucurbit Ash (Erysiphe cichoracearum, Sphaerotheca fuliginea)

75 ml / 100 L water

3 day

Tomato (Field)

Mildio (Phytophthora infestans)


Early blight(Alternaria solani)

75 ml/100 L water

3 day

Watermelon

Alternaria leaf blight

(Alternaria ucumerina)

75 ml/da

3 day

Pepper (Greenhouse)

Ashing (Leveillula taurica)

75 ml/100 L water

3 day

Paddy

Paddy blight (Pyricularia aryzae)

100 ml/da

28 day

* It is not used in vineyards where harvest leaves will be harvested.