ERFİDAN 25 EC

Explanation
PREPARATION OF THE PLANT PROTECTION PRODUCT FOR APPLICATION:

The plant protection product calculated over the recommended dosage is first mixed with some water in a separate container. The tank of the application machine is half filled with water. While the mixer of the machine is running, the mixture is added to the tank. The mixing is continued and the tank is completed with water. Mixing process continues until the application is completed. Use the prepared plant protection product on the same day.

Calibration:

Before the application, the application machine should be calibrated. The amount of mixture to be given to a certain area should be well adjusted in order to provide a good coating. Applications should be done in cool hours of the day in windless or less windy weather conditions.

CLEANING OF THE SPRAYING MACHINE:

Empty the sprayer tank safely immediately after the application is completed. After filling the tank with clean water, run the mixer and spray system to ensure all parts are washed. Do not wash near water sources. Do not discharge washing water and wastes into water sources.

USAGE OF PLANT PROTECTION PRODUCT:

Cereal powdery mildew in barley; When the disease progresses towards the upper part of the plant by considering the climatic conditions, the application of green parts should be started in order to prevent the upper leaves, especially the flag leaf, from being transmitted by the disease.

Vineyard powdery mildew:

1.Application: In the period when the shoots are 25-30 cm before flower

Application 2: In the period when there are flower buds before flowering

3. Application: In the period when the flower petals are falling and the small pellets of the groves are large.

4.and other applications: It is applied to the grains until the fall period according to the effect time of the plant protection product used after the third application.

Cucurbitaceae powdery mildew (cucumber): When the first signs of disease are seen, application is started. The application continues depending on the severity of the disease, climatic conditions and duration of the crop protection product. The application should be interrupted when the daily average temperature is above 27 C and its proportional humidity is below 50%.

Powdery mildew in eggplant, Tomato (Greenhouse), Eggplant (Greenhouse), Pepper (Greenhouse): Applications should be done when the first signs of disease are seen in the greenhouse. Applications are made according to the climatic conditions.

INFORMATION ABOUT RESISTANCE:

Plant protection product named ERFIDAN 25 EC is a fungicide classified as Group G1: 3 according to its mechanism of action. Repetitive applications of plant protection products with the same mechanism of action promote resistance development. For this reason, to delay developing resistance, do not exceed the total number of applications recommended by ERFIDAN 25 EC in the same season. In cases where the application should be repeated, pay attention to the use of plant protection products with a different mechanism of action (except group G1: 3).

MIXTURE STATUS:

A pre-mix test is recommended before mixing with other plant protection products.

• Read the label first.
• Do not use at home
• Keep away from children, food and animal feeds.
• Do not eat, drink or smoke during the application of the plant protection product.
• Do not let people and animals enter the field for 1 day.
• To prevent risks to human and environmental health, use as recommended and at the recommended dosage.
• It is strictly forbidden to use other than the recommended products.

Rinse well by putting clean water up to ¼ in the empty packages of the product used. Pour the rinse water into the application tank. Repeat this process 3 times.

POISONING SYMPTOMS:

Stress, reflex reduction and movements are imbalanced in muscles.

FIRST AID MEASURES:

After Inhalation: Call a doctor or poison control center. Move to fresh air. Keep the patient warm and not rest, but rest.

After Skin Contact: Skin should be washed immediately with plenty of water and soap, if any, should be washed with polyethylene glycol 400 followed by plenty of water. If symptoms persist, consult a doctor.

After Eye Contact: If there are lenses in the eyes, remove them after the first five minutes, then continue washing the eyes. If irritation occurs and persists, go to the doctor.

After Swallowing: Do not induce vomiting. Consult a doctor or poison control center. Shake the pain.

ANTIDOTE and TREATMENT:

It has no special antidote. Treatment is applied according to the symptoms.

CONTENTS:

Triedimenol

HAZARDOUS EXPRESSIONS (H)

H226: Flammable liquid and vapor.

H302: Harmful if swallowed.

H312: Harmful in contact with skin.

H315: Causes skin irritation.

H318: Causes serious eye damage.

H319: Causes serious eye irritation.

H332: Harmful if inhaled.

H360: May damage the unborn child or damage reproduction.

H412: Long lasting, very toxic effect in the aquatic environment.

Precautionary Statements (P)

P273: Avoid release to the environment.

P280: Wear protective gloves / protective clothing / eye protection / face protection.

P370 + P378: In case of fire: Use water spray, carbon dioxide, foam, dry powder for extinction

P501: Dispose of contents / container in accordance with local regulations.

EUH401: Follow the instructions for use to avoid risks to human health and the environment.

MATTERS TO BE CONSIDERED WHEN USING AND STORING:

• It is poisonous to the fish. Avoid contaminating underground and surface waters.
• It is poisonous to bees. Do not use during the flowering period.
• Keep the plant protection product closed in its packaging.
• Do not contaminate plant protection product and its residues into ponds, streams and lakes.
• Do not use in the weather when wind drift may occur.
• Do not allow the product to moisten during storage. Since this can cause chemical changes, it can reduce the fungicide effect of plant protection products.
• Keep away from fire and sparks.

STORAGE STATUS:

When stored unopened in its original packaging under normal (cool and dry) conditions, there is no change in the physical, chemical and biological properties of the product outside the tolerance limits for 2 years.

COMPANY STATEMENT:

The manufacturers guarantee the quality of plant protection products provided that they are sold in their original packaging. Manufacturers do not accept responsibility for any damage caused by improper storage of plant protection products or deficiencies in following recommendations.

LICENSE OWNER AND MANUFACTURER COMPANY:

ERTAR KİMYA Agricultural Products Tools Manufacturing Market. Singing. ve Tic. Ltd. Sti.

Acıdere OSB Mah. Sanayi Zafer Cad. No: 8 Saricam / ADANA

Tel: 0 (322) 456 19 45 Fax: 0 (322) 456 19 47

info@ertarkimya.com.tr www.ertarkimya.com.tr

PLANT AND HAZARDOUS ORGANISMS TO BE USED:

(*) It is not used in vineyards where harvesting vine leaves will be harvested.